Manual
Startup/Shutdown 5-1
5 Startup/Shutdown
This section describes how to startup and shutdown the C-730 Flux for production,
programming, or service. This procedure is a general recommendation—your actual startup
and shutdown procedure may vary. See your own documentation, if available. The
following procedure assumes that an Asymtek technician has already installed your system
and that all power cables are connected to the facility AC power source.
Startup
The following procedure describes how to start up your Century Series system for
production, programming, or service.
When your system is ready to operate, it turns ON the green system status LED on the
Control Panel and the green light on the Light Beacon. For explanations of the dispensing
status colors, see Table 4-6.
To locate machine controls for startup procedures, see Figure 2-5, Figure 4-2 and Figure
4-3.