Manual

Operation 4-35
To adjust the conveyor air pressure:
1. Verify that the dispensing system is ON.
The System Status LED and Light Beacon should be yellow or green.
2. At the rear of the dispensing system, locate the conveyor air regulator (see Figure
4-10).
3. Pull the regulator knob out to unlock, then while watching the gauge rotate the
regulator knob in the appropriate direction.
> Clockwise (right) to increase pressure up to the desired level.
> Counter-clockwise (left) to decrease pressure. To avoid false readings, lower the
pressure past the target level, then rotate the regulator clockwise (right), to raise
pressure up to the desired setting.
4. Restore the regulator to the locked position.
End of Procedure