User guide

Operation 4-13
Table 4-5 Dispensing Status Control Functions
Button/Indicator Function
RESET
CONVEYOR
STATUS
PAUSE
Conveyor Status has two buttons, Pause and Reset.
Pause halts the conveyor, and its LED indicates that the conveyor has been
paused. Press Pause again to resume conveyor movement.
Reset clears the controller after its LED indicates that a fault condition has
occurred.
INTERLOCK
INTERLOCK
RECOVERY
Interlock is a key-activated safety feature that prevents the conveyor and the
Dispensing Head from moving while the access doors are open. During
dispensing operations, this helps prevent personal injury or damage to the
dispensing system.
For more information on Interlock, see the Safety section of this manual.
RESET
DISPENSER
STATUS
Dispenser Status LEDs are color-coded for each dispensing status condition. For
an explanation of the different status conditions, see Table 3-3, Beacon Color
Indications. A beacon light has the same meaning as a Dispenser Status LED.
Press the dispenser status RESET button after the condition that triggered the red
“abort” LED has been corrected. This will reset the dispenser electronics.
NOTE: After you press the dispenser status Reset button, you must press the
Find Home button to re-establish motor references.