Instruction Manual

7-6 Maintenance
Heated Vacuum Tooling Plate Maintenance
The Vacuum Heated Tooling Plate operator-performed maintenance consists of cleaning.
See Table 7-3 below. For other maintenance, contact Asymtek Technical Support Group.
WARNING! The Vacuum Heated Tooling Plate can get very hot and remain hot
for an hour after being turned to OFF. Never touch it while the
system is ON or after it has been turned off before it has cooled off.
CAUTION! Do not attempt to over-tighten the vacuum-hole screws. Frequent
over-tightening may cause thread damage and vacuum leaks.
? NOTE Ensure that system is off before performing maintenance.
Table 7-3 Heated Vacuum Tooling Plate – Preventive Maintenance
Maintenance Procedure Recommended Frequency Instructions
Using Phillips-head
screwdriver, hand-tighten
screws.
Inspect Tooling Plate Vacuum
screws and screw-holes
As needed or quarterly
Using Isopropyl Alcohol (lPA),
clean and wipe off fluid spills
with a soft bristle and clean
lint-free shop rag.
General Cleaning Daily
Using Isopropyl Alcohol (lPA),
clean and wipe off fluid spills
clean with a lint-free shop rag.
TIP Record-keeping facilitates proper use of the system and is beneficial
to maintaining optimum performance. Asymtek offers a warranty
which is predicated on the proper use and service attention of the
system by the owner operator.