Instruction Manual

vii
Table of Figures
Figure 2-1 Front View....................................................................................................2-2
Figure 2-2 Dispensing Area ..........................................................................................2-3
Figure 2-3 Lower Cabinet..............................................................................................2-4
Figure 2-4 Rear View ....................................................................................................2-9
Figure 2-5 Rear View Close-Up ..................................................................................2-10
Figure 3-1 Safety Warning Labels, Front View .............................................................3-4
Figure 3-2 Safety Warning Labels, Rear View ..............................................................3-5
Figure 3-3 EMO Location on Dispenser Control Panel .................................................3-9
Figure 3-4 Main Power Inlet and Main Power Circuit Breaker ....................................3-10
Figure 3-5 Earthquake Protection, Side View .............................................................3-13
Figure 4-1 Operational Flow Chart................................................................................4-3
Figure 4-2 Computer Front Panel .................................................................................4-6
Figure 4-3 Control Panel ...............................................................................................4-9
Figure 4-4 Light Beacon..............................................................................................4-16
Figure 4-5 Main Air Gauges and Regulators...............................................................4-19
Figure 4-6 Fluid Pressure Gauge and Regulator ........................................................4-21
Figure 4-7 Valve Pressure Gauge and Regulator .......................................................4-23
Figure 4-8 Pneumatic and Electrical Connections Shown for Single Valve Configuration
Using DP-3000) .....................................................................................................4-25
Figure 4-9 Typical Dual-Valve Configuration Shown with DV-6000 as Valve 1 and DP-
3000 as Valve 2.....................................................................................................4-26
Figure 4-10 Pneumatic and Electrical Connections Shown for Single-Valve
Configuration Using DV-6000................................................................................4-27
Figure 4-11 Electrical Connection Detail.....................................................................4-28
Figure 4-12 Heated Vacuum Tooling Plate .................................................................4-30
Figure 4-13 HT-1000 Temperature Controller.............................................................4-31
Figure 4-14 HT-2000 Temperature Controller.............................................................4-31
Figure 4-15 4-Channel Temperature Controller ..........................................................4-32
Figure 7-1 Water Trap...................................................................................................7-3
Figure 7-2 Purge Boot Close-Up...................................................................................7-5
Figure 7-3 Heated Vacuum Tooling Plate .....................................................................7-7
Figure 8-1 Dispensing and Vision Areas on the Work Platform, Single Action
Dispensing Using One DP-3000..............................................................................8-3
Figure 8-2 Dispensing and Vision Areas on the Work Platform, Dual Action Dispensing
Using Two DV-6000 Valves.....................................................................................8-4
Figure 8-3 Dispensing and Vision Areas on the Work Platform, Dual Action Dispensing
Using One DP-3000 Valve and One DV-6000 Valve) ............................................8-5
Figure 9-1 AV-700 Vision System................................................................................9-3
Figure 9-2 F-Stop Ring ................................................................................................9-5
Figure 9-3 Focus Height Ranges ...............................................................................9-10
Figure 9-4 AV-2550 Vision System............................................................................9-11
Figure 10-1 Height Sensor...........................................................................................10-1
Figure 10-2 Height Sensor Installation.........................................................................10-3
Figure 10-3 Height Sensor Installation with Bracket Spacer........................................10-3
Figure 10-4 Probe-to-Needle Alignment ......................................................................10-8
Figure 11-1 HT-04........................................................................................................11-2
Figure 11-2 HT-06........................................................................................................11-3
Figure 11-3 HT-10N .....................................................................................................11-3