Instruction Manual

Troubleshooting 6-5
Heated Vacuum Tooling Plate Troubleshooting
Table 6-2 Heated Vacuum Tooling Plate Troubleshooting
Symptom Possible Cause Recovery
A. Missing Vacuum Hole
screw(s)
Replace screw(s).
1. Hissing air leak
B. Other pneumatic leaks
Contact Asymtek Technical
Support Group
A. Wrong display unit Change display unit (F or C)
2. Erroneous temperature
display
B. Out of calibration
Recalibrate. Call Asymtek
Technical Support Group
3. Workpiece part not held
steady
Check for improper open or
plugged vacuum holes
Remove and install screws as
applicable
4. Vacuum does not start or
fails to work properly.
System has low or no air
pressure
1. Verify air is connected to
facility air supply
2. Set Main Air Regulator to
approximately 80 psi
5. Temperature Controller
fails
Hardware or software failure
Call Asymtek Technical
Support Group