Instruction Manual

Startup/Shutdown 5-1
5 Startup/Shutdown
This section describes how to start up and shut down the C-720 for production,
programming, or service. These procedures are general recommendations. Your actual
startup and shutdown procedures may vary. See your own documentation, if available. This
assumes that an Asymtek technician has already installed your system and that all power
cables are connected to the facility AC power source.
Startup
The following procedure describes how to start up your Century Series system.
When your Century Series system is ready to operate, it turns on the green system status
LED on the Control Panel. For explanations of the dispensing status colors, see Table 4-6.
To locate dispensing system controls for startup procedures, see Figure 2-5, Figure 4-2, and
Figure 4-3.