Instruction Manual

4-34 Operation
Set Tooling Plate Temperature Control:
The following procedures describe how to operate the HT-2000 Temperature Controller,
how to set the temperature, and how to select the Celsius or Fahrenheit display.
? NOTE For the 4-Channel Temperature Controller and advanced operation,
refer to Section 11 − Needle Heater.
? NOTE If you are running FMW and using the Needle Heater with a 4-
channel temperature controller, the Fluidmove software controls the
Needle Heater.
1. The Temperature Controller display can be shown in Celsius or Fahrenheit. To change
the display:
a) Press and hold $and
ENTER simultaneously for 5 seconds.
• The display will show SEC (seconds) and a number from 1 to 4.
b) Press
INDEX until UNIT displays.
c) Use the #$to toggle between Fahrenheit and Celsius.
d) Press
ENTER to record the desired unit display.
2. If not already ON, press the Start (I) button on the system Control Panel.
3. Press the switch on the HT-2000 Temperature Controller front panel to
ON (I).
4. Press the INDEX on the HT-2000 Temperature Controller until SP1 is displayed (Set
Point 1).
5. Use the #$to
adjust the temperature to the desired value, then press ENTER.