Instruction Manual

Safety 3-7
Light Beacon (option)
Located at the top right corner of the system, the Light Beacon is a visual warning device
that indicates different Interlock status conditions by turning on a different colored light for
each condition. See Table 4-6 for an explanation of each color condition. The colors
displayed on the Light Beacon match the colors displayed on the
DISPENSER STATUS
LED’s on the Control Panel of the Century Series System.
Safety Interlock Door Sensors
The Safety Interlock Door Sensors on Century Series systems detect the door status (open or
closed). Depending on the Safety Interlock mode, access for certain operations is limited as
the door sensors activate the Safety Interlock system. A key-activated switch operates the
Safety Interlock system. You can remove the key to prevent an inadvertent mode change.
Safety Interlock Recovery Light
The Safety Interlock Recovery Light is located on the Control Panel to the left of the
DISPENSER STATUS LED’s (see Section 4 − Operation). When the light is ON, you can
safely access the inside of the dispensing area. When the light is OFF, accessing the inside
of the dispensing area will cause a non-recoverable interlock condition to occur. This means
that the motor power turns OFF, the system loses master references, and the red “abort”
Status LED will light.
To recover from an abort condition:
1. Close the doors.
2. On the Control Panel:
a. Press
DISPENSER STATUS RESET.
Wait three seconds.
b. Press
FIND HOME.
3. In Fluidmove, click on the GO button.