Instruction Manual

Needle Heater 11-1
11 Needle Heater
Overview
The Needle Heater consists of a temperature controller and a heating element that attaches
to the dispensing needle. The heating element is selected for compatibility with your valve
or fluid pump (see Table 11-1). On M-2000 and Millennium Series dispensing systems
equipped with heaters, the temperature controller is an integrated feature. The heating
element plugs into outlets on the dispensing head and the temperature is controlled through
the Fluidmove software. On most Century Series dispensing systems, the temperature
controller is a separate, non-integrated feature (see Figure 11-4).
Your service technician installs the Needle Heater as part of the dispensing system
installation or during an upgrade. This section describes the function and operation of the
Needle Heater.