Instruction Manual

9-6 Vision System
To adjust the focus of the image:
1. To adjust focus, twist the Focus ring until focused. If focused, skip step 2.
2. If still not focused, perform as follows:
a. Using a 5/64-inch hex key, loosen the setscrews holding the camera in place.
b. Move the camera up or down until the displayed image is in focus.
c. When satisfied, tighten the setscrews to secure the camera.
d. Repeat step 1.
? NOTE Before using the vision system to program or run a dispensing
program, run Valve Offsets or Calculate Master Offsets in FMW.