User Manual

Vision System 9-3
Operation
When the dispensing system is ON, the light ring illuminates and the camera turns ON. The
camera magnifies the workpiece image and sends it to the system computer. The light ring
card inside the computer supplies the camera with power. It also receives the camera signal
and sends it to the video card. The video card displays an image on the computer monitor
with a crosshair overlay. The crosshair is calibrated to the XY location using a Fluidmove
setup routine.
During a programming session, the dispensing head and attached camera are moved to a
specific location above the workpiece using the motion controls. The crosshairs are centered
over the starting point of a dispensing pattern. The exact location is taught and recorded in
the dispensing program. When the dispensing program is run, the operator positions the
crosshairs over the starting point and starts the dispensing operation.
3
1
.2
4
2
2
5
7
SE
R
IE
S
2
H
E
W
L
E
T
T
PA
C
K
A
R
D
5/75
O
R
C
A
O
R
C
A
O
R
C
A
Figure 9-1 AV-700 Vision System
Video
Card
Light Ring
Card
Cable Harness
NER Diffused
On Axis Light
and Camera
Light Ring
and Camera
Video
Capture Card