User Manual

Startup/Shutdown 5-3
(Continued)
14. Select Valve Offsets
Valve OffsetsValve Offsets
Valve Offsets, or Calculate Master Offsets
Calculate Master OffsetsCalculate Master Offsets
Calculate Master Offsets.
> If the Calculate Master Offsets
Calculate Master OffsetsCalculate Master Offsets
Calculate Master Offsets command is grayed out (not available), go back to Needle
NeedleNeedle
Needle
Setup
SetupSetup
Setup, select Needle Setup Parameters
Needle Setup ParametersNeedle Setup Parameters
Needle Setup Parameters, click on Calculate Master Offsets
Calculate Master OffsetsCalculate Master Offsets
Calculate Master Offsets, click on OK
OKOK
OK, then
repeat this step.
15. Follow the on-screen prompts (see your Fluidmove manual) until the offsets routine is
complete.
> If you have any questions, consult the On-line Help.
16. In the FmNT Main Window…
> Click on Teach a Program
Teach a ProgramTeach a Program
Teach a Program to create or edit a production program. See your Fluidmove
manual for more details. (STOP HERE)
> Click on Run a Program
Run a ProgramRun a Program
Run a Program to run a production program. This brings up the Production
Window. (CONTINUE BELOW)
17. In the Production Window, click on Load
LoadLoad
Load.
18. Select the program you wish to run.
19. Click on OK
OKOK
OK. This loads the production program into memory.
20. Click on Run
RunRun
Run.
21. Select Run Production
Run ProductionRun Production
Run Production. This brings up the Run Window.
22. Click on Go
GoGo
Go. This activates the dispensing process.
See the Fluidmove
®
for Windows NT Installation & User Guide for further instructions.