User Manual

Operation 4-31
Conveyor Air
Located on the rear of the dispensing system (see Figure 4-9), the Conveyor Air gauge and
regulator controls air pressure that moves the conveyor’s stop pins, bar clamps, and Under
Board Support (option).
The recommended conveyor air pressure is 3.86 kg/cm
2
(55 psi).
? NOTE If air pressure is too high, you can damage parts. If pressure is too low,
the stop pins, bar clamps, and under board support (option) will not
work.
Figure 4-13 Conveyor Air Gauge and Regulator
To adjust the conveyor air pressure:
1. Verify that the dispensing system is ON.
The Light Beacon should be yellow or green.
2. At the rear of the dispensing system, locate the conveyor air regulator (see Figure 4-9).
3. Pull the regulator down, then while watching the gauge rotate the regulator…
> Clockwise (right) to increase pressure up to the desired level.
> Counter-clockwise (left) to decrease pressure. To avoid false readings, lower the
pressure past the target level, then rotate the regulator clockwise (right), to raise
pressure up to the desired setting.
4. Push the regulator up to return it to the locked position.
Conveyor Ai
r
Regulato
r
Conveyor Air
Gauge
Facility
A
ir