User Manual

Operation 4-23
Conveyor Adjustments
The conveyor should not need adjustments during normal operation. However, when
programming or changing parts, you may need to move the part to the left or right, or
change the width of the conveyor rails. Follow the procedures below.
To move the conveyor belts left or right:
1. Press
CONVEYOR on the Control Panel (see Table 4-4).
> The conveyor LED blinks when CONVEYOR control is active.
2. Press the left or right arrow to move the belts in that direction.
To adjust the distance between the conveyor rails:
1. Press
CONVEYOR on the Control Panel (see Table 4-4).
> The conveyor LED blinks when CONVEYOR control is active.
2. Press the up arrow to widen the gap between the rails.
> The rear conveyor rail moves (the front rail is stationary).
3. Press the down arrow to narrow the gap between the rails.
Conveyor Troubleshooting
See Conveyor Troubleshooting in Section 6.
Conveyor Maintenance
See Conveyor Maintenance in Section 7.