Manual
Height Sensor 10-7
Always Mode does not compensate for Z-height with the needle
sensor. Selective Mode increases the processing time to the
dispensing head.
16.
Press [Enter].
17.
Answer “Yes” if asked the question “
”
18.
Press [Enter].
19.
Select from the menu.
20.
Select .
21.
Set the to 0.12.
This setting should be satisfactory for most dispensing applications.
However, you may need to experiment with this value.
22.
Accept the default value for .
23.
Select .
24.
Set the to 2 in/sec.
25.
Set the to 300 in/sec
2
.
A high acceleration value and a slow velocity produce the most
accurate height sensing measurements.
26.
Select from the menu.
27.
Press [Enter].
28.
Select .
29.
Press [Enter].
30.
Answer “ ”
31.
Press [Enter].