Manualshelf

Manual

ManualsBrandsNordson ASYMTEK ManualsEquipmentCentury Series C-708 AICE - Operations Manual
81828384858687888990
10-4 Height Sensor
Setup
Before performing any dispensing programs with the Height Sensor, make sure that the
Height Sensor is properly set up. To set up the Height Sensor, use your dispensing software
to run a Height Sensor Setup procedure.
During the Height Sensor Setup process, you can assign values to control various Height
Sensor parameters. In FMW, you can control the Up and Down Speed and Acceleration of
the dispensing head during a height sense, the Maximum Search Depth that the dispensing
head will descend in search of the substrate, and the Retract Distance after a height sense. In
FMDOS, you can control the Z-Velocity and Acceleration of the dispensing head during a
height sense. You can also select a mode for establishing automatic height senses at
specified points during production. Refer to specifications on page 10-16 for recommended
settings.
There are separate Height Sensor setup procedures for FMW and for FMDOS.
Make sure that your Height Sensor is properly set up prior to programming.
Height Sensor Setup in FMW
1.
In the FMW Main Window, click on .
2.
Select from the drop down menu.
The Setup Height Sensor dialog box opens, showing the various
configurable parameters.
3.
Select a .
In FMW, a dispensing program must contain a height sense command unless
there is no danger of the dispensing head descending too low. If there is no
danger, select . If is not selected and no height sense
command is found, an error will occur.
will check the dispensing program for a height sense
command before any movement of the dispensing head occurs.
will move the dispensing head to the first commanded
position before checking the dispensing program for a height sense
command. This is the default setting.
Up Speed, Down Speed, Acceleration, Maximum Search Depth and
Retract Distance values are all set at the Asymtek factory prior to
shipping, and should not need to be changed. However, if you
experience problems with your Height Sensor performance, use these
parameters to try and correct the problem.
4.
Click on .