Manual

v
Table of Figures
Figure 2-1 Basic C-702 System.......................................................2-3
Figure 2-2 C-708 with Options.........................................................2-4
Figure 2-3 C-708 AICE ....................................................................2-5
Figure 2-4 Basic Dispensing Area ...................................................2-6
Figure 2-5 C-702 Rear View............................................................2-10
Figure 2-6 C-708 Rear View with Options.......................................2-11
Figure 2-7 C-702/C-708 Rear Panel Connectors ............................2-13
Figure 3-1 Programming Mode........................................................3-2
Figure 3-2 Production Mode ............................................................3-3
Figure 3-3 Century Series Control Panel.........................................3-4
Figure 3-4 Century Series Control Panel with Dual Gauges ...........3-5
Figure 4-1 Location of Safety Warning Labels ................................4-3
Figure 7-1 X-Axis Lubrication ..........................................................7-3
Figure 9 –1 AV-700 Vision System..................................................9-2
Figure 9 –2 Focus Height Ranges...................................................9-10
Figure 9 –3 AV-2550 Vision System................................................9-11
Figure 10-1 Height Sensor...............................................................10-1
Figure 10-2 Height Sensor Installation ............................................10-3
Figure 10-3 Probe-to-Needle Alignment..........................................10-10
Figure 10-4 GU Adjustment Locations ............................................10-12
Figure 11-1 NS Series Needle Sensor ............................................11-1
Figure 11-2 NSZ Series Needle Sensor ..........................................11-1
Figure 12-1 HT-04 ...........................................................................12-2
Figure 12-2 HT-06 ...........................................................................12-3
Figure 12-3 HT-10N.........................................................................12-3
Figure 12-4 HT-2000 Temperature Controller.................................12-4
Figure 12-5 HT-06 on a DV-6000 Pump with Luer Lock Fitting ......12-7
Figure 12-6 HT-10N on a DV-6000 Pump.......................................12-7
Figure 13-1 Expanded I/O (shroud partially removed) ....................13-1
Figure 13-2 Light Curtains ...............................................................13-7
Figure 13-3 Vacuum Heated Tooling Plate .....................................13-10
Figure 13-4 HT-2000 Temperature Controller.................................13-11
Figure 13-5 Light Beacon ................................................................13-14
Figure 13-6 Low Air Pressure Sensor .............................................13-16
Figure 13-7 Hour Meter ...................................................................13-18