Manual
Vision Systems 9-5
Adjustments for the AV-700
The camera and built-in light ring on the AV-700 may require adjustments to the focus and
the brightness. There are separate procedures for FMW and FMDOS.
To adjust the focus using FMW:
1.
Using a 5/64 inch hex key, loosen the setscrews holding the camera in place.
2.
Move the camera up or down until the displayed image is in focus.
3.
When satisfied, tighten the set screws to secure the camera.
4.
In the FMW Main Window, click on .
5.
Select .
6.
Select and follow the on-screen prompts. Consult on-line Help if
necessary.
To adjust the focus using FMDOS:
1.
On the FMDOS Main Program menu, select .
2.
Select .
A dialog box opens telling you which dot style Fluidmove will use as the test
dot. Either accept the default dot, or type in the number of the preferred dot
style.
You are then asked to select or . If
you have not yet established a Global Z Height, then use the front panel arrow
controls to move the dispensing head to the desired location and height to
dispense the test dot.
3.
Press [F5]
or
[Pause].
The dispensing head will move after your response.
4.
Use the front panel arrow controls to move the dispensing head to the location of
the dot just dispensed. Center the crosshairs in the video display over the dot.
5.
Press [F5]
or
[Pause].
The dispensing head will move after your response.
6.
Press [F5]
or
[Pause].