Manual

Maintenance 7-1
7
Maintenance
Routine Maintenance
Routine maintenance of your Century Series system can prevent part degradation and ensure
high quality performance for every production run. There are several simple procedures you
can perform on a regular basis to guarantee quality dispensing and optimize system
performance.
It is essential that you follow all safety warnings and consider all safety warning labels when
performing these procedures. The following procedures should be performed every month,
unless needed sooner. If dispensed material drips on the system, wipe it off immediately.
Table 7-1 Maintenance Schedule
Maintenance
Procedure
Recommended
Frequency
Instructions
Control Panel Weekly
1. Turn the Main Power Switch
OFF
at the rear
of the Century Series system.
2. Clean and wipe the Control Panel using an
ammonia-based cleaner.
Door/Side Panel Weekly
Clean and wipe the panels using an ammonia-
based cleaner.
Miscellaneous
Surfaces
Weekly
1. For damp spills, wipe up with a dry, soft rag.
2. For dried spills, clean with an ammonia
based cleaner.
Lubricate the
X- Axis
Monthly
See Lubricating the X-Axis below.