Manual

6-2 Troubleshooting
Troubleshooting
Use the table below to identify possible solutions to some common operator issues.
Table 6-1 Troubleshooting Guide
Symptom Recovery
1. Machine dispenses in the wrong X, Y or Z
location.
A. If the Needle Sensor is installed, select
Download Program 6 (
) using
Program
. Press
Start
.
B. If a Vision System is installed, go to
and select
. Restart dispensing program.
C. If a Height Sensor is installed, go to
and select
. Restart dispensing program.
2. No response from Control Panel Buttons.
A. Press
SYSTEM RESET
, wait three
seconds then press
FIND HOME
.
If motion occurs, restart the dispensing
program.
If no motion occurs notify a service
technician.
B. Turn the Safety Interlock Key to the
position and press
SYSTEM RESET
, wait
three seconds, then press
FIND HOME
.
If motion occurs, see “Safety Interlock
Failure” in this table.
If no motion occurs, call a service
technician.
3. Safety Interlock fails to Reset.
A. Make sure both doors are closed, then
press
SYSTEM RESET
. Restart the
dispensing program if failure is corrected.
B. Call a service technician.