Manual

5-4 Start-up/Shutdown
Programming Start Up in FMW
This is a minimal procedure for beginning a programming session. A more detailed
procedure is outlined in the Fluidmove for Windows User Guide.
1. Press the Main Power Switch, at the back of the Century Series system, to
ON (
)
.
2. Press the
Power Switch
on the Control Panel
ON (
).
3. Press the Power Switch on the computer and monitor
ON (
).
4. Close all running programs except FMW.
5. Locate the FMW Program Group.
6. Double click on the FMW icon to start FMW.
If you receive any error messages concerning the motion controller, exit FMW,
press
SYSTEM RESET
on the Control Panel, and repeat Steps 1-6.

Steps 7-9 only need to be performed on first start up after initial
installation, or after any major hardware changes. If you are certain
that no major hardware changes have occurred since your last
programming session, skip Steps 7-9 and continue with Step 10.
7. Click on
.
8. Select
.
9. Follow the on-screen prompts.
Consult On-line Help for questions or consult the FMW manual.
10. Select from the Main Window.
Perform your dispensing programming using the Process Toolbar/Program
Commands Toolbar.