Manual

2-14 Introduction
C-702/C-708 Series Connectors
This section briefly describes each connector and its function within the system. Only
service technicians should access the connectors, fuses and electrical connections underneath
the shroud. If you need access to the connectors, consult the Century Series Service Manual.
If you have the Vision System option, two Vision System cables will extend from the Rear
Shroud to connect to the computer.
Air Supply Connectors
These four connectors supply air to the fluid pump, syringe and other mechanics.
Expanded I/O Ports Connector
The expanded I/O cable connects to this connector.
Main Power Inlet
The Main Power Cord connects to the Main Power Inlet.
Power Entry Module
This module provides power to the main mechanics of the system. It contains a fuse to
prevent damaging components in case of a power surge.
RS-232C Connector
This port communicates to the computer through an Asymtek CB-01 cable. The CB-01 cable
connects to the adapter cable.
Safety Interlock Cable Connector
The Interlock System connects to this port to shut down power in an emergency.
Valve Cable Connector
Power cables for the DV-06, DV-6000 or DP-2000 fluid pumps are connected to this port.
Z-Axis Connector
The Z-Axis power cable connects to this port.
Z-Axis Fuse
This fuse provides a safeguard for the Z-Axis.