Manual

2-12 Introduction
Rear View Features
Below are short descriptions of the various parts and modules of the systems and their
functions.
Air Filter
This filters out particles and impurities in the facility air supply.
CB-01 Cable
This cable connects to the RS-232C serial port of the Century Series system.
Cooling Fan
The fan is designed to cool the inside dispensing area.
Expanded I/O Ports A, B and C
These ports allow additional I/O access for adding options to the Century Series system. The
Expanded I/O Ports is an option on all Century Series systems.
High Air Pressure Relief Valve
This safety valve opens when the incoming air pressure exceeds 100 psi. If the incoming air
pressure reaches 120 psi the valve will open fully to bleed off the excess air pressure.
Hour Meter
The meter monitors the dispensing system operation hours for maintenance logging. The
Hour Meter is an option on all Century Series systems.
Main Air In
The Main Air In attaches your facility air supply to the Century Series system.
Main Power Cord
The cord connects the Century Series system to the facility power supply.
Main Power Switch
Located on the rear of the system, the Main Power Switch controls all electrical power going
into the Power Manager of the system. It cuts all power to the dispensing system.
Shroud
The shroud protects the rear connectors. Operators should not remove it.