Manual
11-6 Needle Sensor
Setup in FMDOS
Only the NS Series Needle Sensor uses FMDOS. The software does not recognize the Load
Cell on the NSZ Series. There are three different setup options available depending upon
your application. They are described below. Option 3 is a Find Next Needle procedure that
must be performed whenever a new needle is installed.
Option 1 – To use the Needle Sensor while creating a
new file
in FMDOS:
1.
Got to .
2.
Select
3.
Fluidmove will prompt you with “How will you use the NS?” Select one of the
options below meeting your programming and dispensing needs.
Press [Enter] on this selection if you want the Needle Sensor
routine to run only when instructed.
: Press [Enter] to run the
Needle Sensor routine automatically on the first run of a repeating program.
: Press [Enter]
to run the Needle
Sensor routine automatically during every program run.
Option 2 – To use the Needle Sensor when not creating a program:
1.
Select from the menu.
2.
Press [Enter].
3.
Follow the instructions in the dialog boxes.
The system will perform a needle sense after you complete these instructions.