Owner manual

Installation 3-3
Component Installation
Your Century C-341 dispensing system is assembled at the Asymtek factory. However, to protect
components during shipment, some are packaged in the Accessories Crate to be installed after arrival.
Installing the Fluid Applicator
The Fluid Applicator should have already been installed on your dispensing system at the Asymtek
factory. If it has not been installed, a trained service technician should install it in accordance with the
appropriate Fluid Applicator manual.
Installing the Computer
CAUTION! Make sure all power sources are disconnected before performing this procedure.
This procedure should only be performed by a trained service technician.
" NOTE All materials are included in the accessories crate that accompanied your
dispensing system.
To install the Computer:
1. Locate the Computer, remove all packaging material, and place it in the desired location.
2. Connect the CB-01 cable at the rear of the C-341 to COM 1 on the computer.
3. Plug the Computer power cable into the facility outlet.
To install the Monitor:
1. Locate the Monitor and power cable, remove all packaging material, and place the Monitor in
the desired location.
2. Plug the Monitor power cable into the Computer outlet or the facility outlet.
3. Connect the Monitor cable to the appropriate port on the back of the Computer and
hand-tighten the thumbscrews.
To install the keyboard and mouse:
1. Unpack the keyboard and mouse and remove all packaging material.
2. Place the keyboard in the desired location.
3. Connect the keyboard cable to the keyboard connection on the back of the Computer.
4. Connect the mouse cable to the mouse connection on the back of the Computer.