Owner manual
3-2 Installation
Uncrating and Placing the Dispensing System
CAUTION! This installation procedure should only be performed by a trained service
technician.
Tools and Materials Needed:
• Adjustable Wrench • Hammer
• Appropriate Personal Protective Equipment • Flat Bar
To uncrate and place the dispensing system:
1. Locate and remove the envelope on the outside of the shipping crate. Open the envelope and
locate the shipping list and uncrating instructions.
2. Referring to the uncrating instruction sheet, use the flat bar and hammer to remove the lid and
sides of the crate.
WARNING! Personnel should wear gloves and safety glasses while removing the top and
sides of the crate. Sufficient personnel should be used to lift and control the crate
top and sides to prevent serious injury to personnel or damage to the dispensing
system.
3. Remove all packaging material from the perimeter of the dispensing system.
4. If applicable, remove bolts anchoring the dispensing system to the floor of the crate.
5. Place the dispensing system over the installation site.
6. Remove all perimeter packaging material from the dispensing area.
7. Remove all tie wraps, tape, foam packaging material, and warning tags from the Dispensing
Head and Tooling Rails.
"NOTE Location of packaging materials to be removed is indicated by the presence of
red warning tags. The amount, type, and arrangement of packaging materials will
depend on your system’s configuration.
8. Use the flat bar and hammer to remove the crate lid and unpack the accessories crate.
! As you unpack each item inside of the box, identify the item, locate it on the shipping
list, and place a checkmark next to the item.