Manualshelf

Owner manual

ManualsBrandsNordson ASYMTEK ManualsEquipmentCentury Series C-341 - Operations Manual
11121314151617181920
Safety 2-7
Emergency Shutdown Recovery
WARNING! Do not restart the dispensing operation until the condition that caused the
emergency shutdown has been alleviated. Failure to comply could cause serious
injury to the user and/or serious damage to the dispensing system.
To recover after an emergency shutdown:
1. Locate and remedy the cause of the emergency shutdown. If necessary, refer to the
Troubleshooting section.
2. Close the Dispensing Area doors.
3. Turn the EMO knob counterclockwise until it pops back into position.
4. Press the
Start (I) button on the Control Panel.
5. Press
Find Home on the Control Panel.
6. Restart your dispensing program. Refer to “
Loading and Running Programs” in the
Operation section.
Lockout of Electrical and Pneumatic Energy
Century C-341 Series Dispensing System electrical and pneumatic components have been designed in
accordance with industry-wide safety standards. However, precautions must still be taken whenever
personnel may be exposed to the unexpected power-up and pressurization of the equipment, or release of
hazardous electrical or pneumatic energy.
WARNING! All personnel working on or around the dispensing system should know the
location of all electrical power supply sources.
WARNING! Lock out and tag out electrical power and pneumatic pressure when performing
service or maintenance work on the dispensing system. Failure to do so could
cause serious injury to the user and/or serious damage to the dispensing system.
To lock out/tag out AC power:
1. Press
Stop on the Control Panel.
2. Exit ECNT
3. Turn the Main Power Switch on the left rear of the system to the
OFF (0) position.
4. Unplug the Main Power Cable from the facility source and lock it in a locked box for safety.
5. Place a warning tag on the Main Power Inlet.
! This tag documents the name of the technician taking the equipment out of operation,
the date, and other facility-required information. It is a warning that the equipment
cannot be put back into operation until the authorized technician has removed the tag.