Owner manual

1-8 Introduction
Rear View Features
1. Main Power Switch and Inlet
The Main Power Switch controls electrical power to the entire dispensing system including the
Computer and Computer monitor. The Main Power Inlet connects the Main Power Cord from the
facility power source to the dispensing system.
2. Exhaust Vent Duct
The Exhaust Vent Duct removes fumes from the dispensing area. A customer-supplied air duct must
be connected from the dispensing system to the facility air ventilation system.
3. Reservoir Air Pressure Pneumatic Switch
The Reservoir Air Pressure Pneumatic Switch toggles air supplied to the fluid reservoir ON and OFF.
4. Air Filter and Water Trap
The Air Filter and Water Trap remove particles and impurities in the facility air supply and are
contained in a single assembly.
5. Main Air Inlet
The Main Air Inlet connects the Century Series Dispensing System to your facility air supply.
6. Fluid Reservoir (Figure B-6 – Included with purchase of Fluid System)
The standard 1/10-gallon fluid reservoir contains conformal coating fluid or solvent.
7. Fluid Filter (Figure B-5 –Included with Purchase of Fluid System)
The Fluid Filter blocks particles in the conformal coating fluid from passing to the Fluid Applicator.
Item Description Item Description
1 Main Power Switch and Inlet 4 Air Filter and Water Trap
2 Exhaust Vent Duct 5 Main Air Inlet
3 Reservoir Air Pressure Pneumatic Switch
Figure 1-4 Rear View
3
1
4
2
5