User Manual

11
Figure 2-2 Conveyor Configuration Window
6. In the Enable/Disable section under the General Configuration tab, click the appropriate
checkbox to enable the stations. A checkmark in the box indicates the station is enabled.
" NOTE The conveyor style is configured at the factory. If a style change is required,
contact Asymtek Technical Support.
7. Click OK.
! The Conveyor Configuration Window closes and you return to the Setup
Conveyor Window.
8. Click Configure for Conveyor 2 (Figure 2-1).
9. Repeat Steps 6 and 7 for Conveyor 2.
10. Click OK.
! The Conveyor Configuration Window closes and you return to the Setup
Conveyor Window.
11. Click OK to return to the Fluidmove Main Window.