User Manual

10
2 Installation
Refer to the Installation section of the Axiom X-1000 Series Installation and Service Manual for standard
installation and setup procedures. In most cases, system configuration is performed at the Asymtek
factory. Typical Dual Conveyor settings are shown below.
Dual Conveyor Setup
To configure the Conveyor:
1. Power on the dispensing system and start Fluidmove as described in the Axiom X-1000
Series Operations Manual.
2. In the Fluidmove Main Window, select Configuration>Setup Conveyors.
! The Setup Conveyors Window (Figure 2-1) opens.
Figure 2-1 Setup Conveyors Window
3. Select MPC555 from the drop-down list for Conveyor 1 type.
4. Select MPC555 from the drop-down list for Conveyor 2 type.
5. Click Configure for Conveyor 1.
! The Conveyor Configuration Window (Figure 2-2) opens.