Installation Manual

Power-up and Testing 5-41
To test EMO effect on Heater Tooling and Needle Heaters:
? NOTE This procedure assumes that FmNT is in the Heater Control Window and that the Heaters
are at their set temperatures.
1. With the Heater Tooling and Needle Heaters at their set temperatures (SP), press the red
EMO knob on the Operator’s Console.
2. Monitor the temperature values shown in the PV column of the Heater Control Window.
> The temperature values in the PV column should indicate that the Heaters are cooling.
This may take several minutes to verify.
3. Restore power to the dispensing system by turning the red EMO knob counterclockwise until
it pops out and then pressing the green
ON (l) button on the Operator’s Console.
4. Monitor the temperature values shown in the PV column of the Heater Control.
> The temperature values in the PV column should indicate that Heater temperature
is rising.
5. Repeat Steps 1 through 4, except use the EMO Switch on the back of the dispensing system.
6. Turn the Heaters OFF by double clicking on the icons in the
On/Off column of the Heater
Control Window.
7. Click on
Exit to return to the Tools Window.
Vision System
Perform the following checks to make sure that the Vision System is ready for operation.
1. In the FmNT Main Window, click on
Teach a Program.
2. In the Programming Window, click on the
Load a Board icon .
3. In the FmNT Main Window, click on
Configuration and then select Setup Vision.
4. In the Vision dialog box, click on the
Setup Reticles button. See Figure 5-21.
5. Using the target box and position controls, move the Camera over the production sample
workpiece clamped in the dispense station. Locate a production fiducial on the workpiece.
6. In the Reticle Settings dialog box, use the lighting controls to vary the light intensity and
red-blue color balance (if applicable). See Figure 5-21.
> For diffuse on-axis lighting (DOAL) systems, the brightness should range from 0 to 255.
> If your system has red and blue LEDs, they should adjust from all red to all blue and all
combinations of the two colors.