Installation Manual

Power-up and Testing 5-39
> If the Heater Tooling does not meet the resistance requirements, it should be repaired or
replaced before proceeding.
9. Reconnect the electrical cables, and close the Hatch.
10. Restore power to the dispensing system by turning the red EMO knob counterclockwise until
it pops out and then pressing the green
ON (l) button on the Operator’s Console.
Item Description
1 Heater On/Off Column
2 Channel (Loop) Name Column
3 Temperature Set Point Column
4 Present Temperature Value Column
5 Message Column
Figure 5-20 Heater Control Window
1
2
3
5
4