Installation Manual

Power-up and Testing 5-3
To connect the system to the facility air supply:
CAUTION! Make sure that facility air pressure is as specified in the Introduction section of
this manual. Higher pressures will damage the dispensing system.
1. Locate the facility quick-disconnect air hose.
2. Make sure the dispensing system Main Air Regulator is closed. Verify facility air pressure is
at 0 psi.
3. Connect the facility air supply hose to the Main Air Inlet connector on the back of the
dispensing system. See Figure 5-2.
> If not already connected, also connect the air hose to the facility air supply.
4. Slowly open the facility air valve and listen for leaks.
> If there is an air leak, identify the source, shut off facility air, and fix the leak before
proceeding.
Item Description
1 Main Air Regulator
2 Quick-Disconnect Fitting
3 Facility Air Hose
4 Main Air Pressure Gauge
Figure 5-2 Main Air Inlet
4
3
1
2