Installation Manual

3-8 Uncrating and Placing
Unpacking the Accessories Crate
CAUTION! This procedure should only be performed by a trained service technician.
To unpack the accessories crate and take inventory:
? NOTE The accessories crate contains technical manuals necessary for the operation of your
equipment, the Light Beacon, the Main Power Cable, and equipment storage cases.
It also contains a tool kit and consumables kit tailored to the configuration of your
dispensing system.
CAUTION! If the dispensing system is being installed in a clean room, remove all packaging
material and follow facility-recommended procedures before moving components
into the clean room.
1. Use the flat bar and hammer to remove the crate lid.
2. Open the plastic bag inside of the crate and locate the accessories check-off sheet.
3. As you remove each item from inside of the box, unwrap and identify the item, locate it on
the shipping list or accessories check-off sheet, and check it off. After you check off each
item, place the item onto a cart for transport to the dispensing system installation site. If any
parts or accessories are missing, contact Asymtek Technical Support.
TIP Except when they are to be used in a clean room, components or kits with many small
parts may be left in their original boxes or bags for transport.
4. Refer to the first two pages of the Installation Checklist in Appendix D of this manual and fill
in as much information as you can at this time.