Installation Manual

X-1000 Installation Checklist
4 of 13
C. Dispenser Set-Up and Mechanics
Step
#
Done
(9)
Test Performed Main Function(s) Tested
10.
When prompted by FMNT, select OK to
send the dispenser to Home.
Check that the dispenser correctly finds
home in X, Y, and Z-axes.
PMAC, Servo interconnect X,
Y, Z axis, Servo system
11.
Ensure that the cables are set to the correct
tensions.
Cable tension
12.
Visually check the area of travel for the Z
head and ensure that there are no visible
obstacles in the entire travel path that the
head may collide with (cowls, front window,
rear tubing and cables) in X, Y and Z.
Work area is clear of
obstructions
13.
Check that Pneumatic/Electrical lines do not
restrict motion or rub against any objects in
the machine.
Routing of cables
14.
Verify that no unusual vibration occurs
during motion throughout the entire
machine.
Dispenser servo control
inconsistencies, binding
15.
Verify travel limits are set properly
(Xmax =195860, Ymax = 212600 )
Travel limits
16.
Ensure that the dispenser motion direction
and speed is controlled correctly by FMNT
(in jog mode, by clicking on the blue
dispense are map, and by clicking directly
on the image in teach mode)
FMNT-PMAC interface
Servo system, vision system
D. Beacon and Interlock
Step
#
Done
(9)
Test Performed Main Function(s) Tested
17. Check that the green beacon is on when the
hood is closed.
Interlock circuitry and beacon
control
18. Check that the yellow Beacon turns on when
the hood is opened and that the machine
goes into low power mode.
Interlock circuitry, beacon and
beacon control
19. Verify that the beacon can be controlled via
the I/O screen and that the red, blue, yellow
and green solid controls work.
Beacon and beacon control