Installation Manual

X-1000 Installation Checklist
1 of 13
Basic Information
Customer: _________________________________________________________________________
System Model Number:_______________________________________________________________
System Serial Number: ______________________________________________________________
Software Version Installed: ___________________________________________________________
System Installed By: _________________________________________________________________
Dispensing Options:
Low Fluid Sensor Needle Heater
 Magnetic  Valve 1
 Capacitive  Valve 2
 Dual-Action Dispensing Head  Needle Sensor
 Height Sensor  Other ________________________________
Dispensing Valves:
Valve 1
Valve 2
 DJ-2100  DJ-2100
 DP-3000  DP-3000
 DV-7000  DV-7000
 Other
_
______________________________
_
 Other ________________________________
Conveyor Configuration:
Conveyor
Direction
Heating Stations Tooling Used Heat Tooling In-line
Equipment
Other
Left to Right Pre-heat Standard Contact Upstream
Right to Left Dispense Lift table Impingement Downstream
Post-dispense None
Initial System Set-Up:
 Shipping Slip is verified.  Conveyor is aligned and leveled.
 Accessories are installed.  Power cable configured for line voltage.
 Air is supplied @ ________ psi.  Line Voltage supplied @ ________ Volts.
 Scale is leveled.  Electrical buffers/UPS installed.
 Backup.Bat is run for Customer.  Backup.Bat copy for TSG is generated.