Installation Manual

3-4 Uncrating and Placing
Placing the Dispensing System
To place the dispensing system:
1. Move the dispensing system over the location where it will be installed.
2. Slowly lower the forklift until the dispensing system Conveyor rail is at the approximate
height of the mating upstream and downstream equipment.
3. Raise or lower each Leveler (foot) as follows until they all touch the floor:
a. Loosen the 1 1/2-inch Lock Nut on the Leveler. See Figure 3-2.
b. Adjust the 1 1/2-inch Post Nut to raise or lower each Leveler as required.
> Turning the Post Nut clockwise raises the Leveler. Turning the Post Nut
counterclockwise lowers the Leveler.
c. Tighten the Lock Nut finger tight.
? NOTE It is not necessary to fully tighten the locking nut at this time.
4. Gently lower the dispensing system and remove the forklift.
Item Description
1Post
2 1 1/2-inch Wrench
3 Leveler (foot)
4Post Nut
5 Lock Nut
Figure 3-2 Placing the System
1
3
5
4
2