Installation Manual

Uncrating and Placing 3-1
3 Uncrating and Placing
Overview
This section covers the following topics:
• Removal of dispensing system from the shipping crate
• Initial placement of the dispensing system
• Unpacking the dispensing chamber
• Unpacking of accessories from the shipping crate
CAUTION! Check the “Tip & Tell” and “Shockwatch” devices, both on the outside of the crate
and on the dispensing system, to make sure that the dispensing system has not
been dropped or tipped. If any of these devices has been activated, contact
Asymtek Technical Support.
CAUTION! If the dispensing system is being installed in a clean room, remove all packaging
material and follow facility-recommended procedures before moving components
into the clean room.
CAUTION! This installation procedure should only be performed by a trained
service technician.