Installation Manual

Parts Replacement 10-43
To install the Image Capture Card or the Video Card:
CAUTION! ESD precautions must be taken while handling the Card or severe damage from
electrostatic discharge may occur.
? NOTE Apply removable thread locker to all threaded fasteners unless otherwise noted.
1. Remove the new card from its ESD protective bag.
2. Align the new card to the connections in the appropriate slot.
3. Gently press down on the card until it is completely seated in the slot.
> The shoulder on the bottom surface of the card will be flush with the top edge of the slot.
4. Install the small Phillips head screw attaching the Card Hold-down Clip to the Computer
Case (see Figure 10-18). Torque to 20 in-lbs (0.230 kg-m).
5. Place the Hold Down Bar across the top of the cards and tighten the slotted thumbscrew.
> Do not use removable thread locker.
6. Close the Computer Door and tighten the two captive, slotted thumbscrews.
> Do not use removable thread locker.
7. Reinstall the Computer inside the Lower Front Cabinet by performing the steps specified in
“Computer Removal and Installation” earlier in this section.
8. Perform a Post-Service Start-up as specified in the Safety section of this manual