Installation Manual

10-42 Parts Replacement
Image Capture Card or Video Card
Use the following procedure to remove and replace the Image Capture Card or the Video Card if fault
isolation procedures in the Troubleshooting section of this manual have confirmed failure.
To remove the Image Capture Card or the Video Card:
CAUTION! ESD precautions must be taken while handling the PWAs or severe damage
from electrostatic discharge may occur.
? NOTE All components and fasteners removed during this procedure should be retained in an
orderly manner and in a safe location for reinstallation or shipment back to Asymtek.
1. Perform a Service Shutdown as specified in the Safety section of this manual.
2. Remove the Computer from inside the Lower Front Cabinet by performing the steps specified
in “Computer Removal and Installation” earlier in this section.
3. Lay the Computer down on its right side. Unscrew the two captive, slotted thumbscrews on
the left side of the Computer and open the Computer Door. See Figure 10-17.
4. Unscrew the slotted thumbscrew on top of the Hold Down Bar and remove the bar.
5. Locate the card(s) that must be replaced.
> The Image Capture Card is located in Slot Number 6. The Video Card is located in Slot
Number 7. See Figure 10-18.
6. Remove the small Phillips head screw from the Card Hold-down Clip.
7. Gently pull up on the card and remove it from the slot.
? NOTE The faulty Computer Card should be returned to Asymtek. Refer to “Return
Material Authorization” in this section for merchandise return instructions.