Installation Manual
Parts Replacement 10-21
8. Remove the Heater Tooling Plate as follows (see Figure 10-10):
WARNING! Heater Tooling Plates present a thermal hazard until they cool. Use thermal
protection or allow Heaters to cool before performing this procedure or serious
burn injury may occur.
a. Disconnect the Heater Power Cable.
b. Disconnect the white (vacuum) or blue (impingement) Air Hose, as applicable.
c. Lift the Heater Tooling Plate off of the Lift Table.
Item Description
1 Heater Tooling Plate (Contact Heater shown)
2 Alignment Pin
3 Front Conveyor Rail
4 Vacuum Hose
5 Lift Table
6 Heater Power Cable
Figure 10-10 Removing/Installing the Heater Tooling Plate
1
2
3
4
6
5