Installation Manual

9-16 Maintenance
11. From the rear of the system, repeat Step 9 for the X and Y cables on the Motor Pulleys.
TIP Moving the Dispensing Head in the X and Y direction while applying the grease
to the motor pulley simplifies this step.
12. Reinstall the Motor Access Panel and reconnect the electrical cables for the X and Y
Servo Motors.
13. Reinstall the Motor Cover and two Rear Safety Covers.
14. Reinstall the dispensing system side panels.
TIP After lubricating the mechanical cables, you might want to re-tension them as
specified in “Positioner Cable Tension Check” in the Power-up and Testing
section of this manual.
15. Perform a Post-Service Start-up as specified in the Safety section of this manual.