Installation Manual

Maintenance 9-13
5. Locate the grease fitting on each of the four X-beam Linear Bearing Cars and four Y-rail
Linear Bearing Cars. See Figure 9-6.
6. Attach grease gun to each fitting and pull the grease gun lever one time to squirt grease into
the bearing.
7. Use a soft cloth to clean up any excess grease.
8. Perform a Post-Service Start-up as specified in the Safety section of this manual.
9. In FmNT, use the Position Controls to move the Dispensing Head back and forth in both the
X-axis and the Y-axis.
10. Open the Hatch and use a soft cloth to remove any excess grease along the rails.
Item Description
1 X-beam
2 Linear Bearing Car (1 of 8)
3 Y-rail
4 Grease Fitting (one at end of each car)
Figure 9-6 Linear Bearing Locations
2
3
4
1
X 2
X 2
X 2
X 2