Installation Manual

9-10 Maintenance

Tensioning the Positioner Cables

Perform the following procedure at the interval specified in Table 9-1 to make sure that the Positioner

Cables are at the proper tension.

Tools and Materials Needed

• Mechanical Cable Tensioning Tool (P/N 48-8002)

To tension the Positioner Cables:

CAUTION! Use only Asymtek tensioning tool (P/N 805478) for adjusting mechanical cable

tension. Use of any other tool or a non-calibrated tool can result in inaccurate

dispensing performance or damage to the dispensing system.

1. Perform a Service Shutdown as specified in the Safety section of this manual.

2. Open the dispensing system Hatch and manually move the Dispensing Head in mid-Y and

mid-X position of the dispensing area.

3. Locate the X, Y, and Y-idle Cable Tensioners. See Figure 9-4.

4. Place the tensioning tool into the holes on top of the leftmost (Y-axis) Cable Tensioner and

twist the tool counterclockwise for two clicks. See Figure 9-5.

Item Description

1 Y-axis Cable Tensioner (left side)

2 X-axis Cable Tensioner (left side)

3 Y-idle Cable Tensioner (right side)

Figure 9-4 Cable Tensioner Locations