Installation Manual

8-130 Troubleshooting

9. Click on the Start button in the lower middle window.

10. Was the Height Sense test within the ranges shown in Table 8-40?

Go to Step 15

Go to Step 11

11. In FmNT, increase the cycle number setting to 100.

12. Click on the

Start button in the lower middle window.

13. When Height Sense test is complete, compare the results with the accuracy parameters specified in

Table 8-40.

14. Was the result within the accuracy parameters specified in Table 8-40?

Go to Step 15

Stop here. Height Sensor meets accuracy parameters. Verify fault. If fault

reoccurs, contact Asymtek Technical Support.

15. Verify that the Height Sensor, Height Sensor Probe, and the Micrometer Locking Screw are installed

correctly and securely.

16. Any adjustments required?

Go to Step 17

Make adjustments and then go to Step 18.

17. Repeat Steps 1 through 13.

18. Was the test result within the accuracy parameters specified in Table 8-40?

Contact Asymtek Technical Support

Stop here. Mechanical adjustment is root cause of Height Sensor fault.

Yes