Installation Manual

Preventing Dispensing System and Workpiece Damage
• Immediately push the EMO button if dispensing system or a workpiece is in danger of
being damaged.
• Use standard ESD precautions when working near ESD-sensitive components. Always wear
a grounding strap and connect it to ground jacks before handling ESD-sensitive workpieces.
• Immediately contain and clean up any caustic or conductive fluid spills as recommended in
the material manufacturer’s MSDS. If fluid gets into internal portions of the machine,
immediately contact Asymtek Technical Support.
• Follow all recommended system maintenance procedures.
• Always keep the dispensing area clear of any fallen workpieces or obstacles.
• Make sure no air intakes or exhaust grilles are blocked when the system is in operation.
• Make sure the Monitor is in a position that will not interfere with the opening and closing of
the Hatch.
Facility Environmental Health and Safety Practices
• Operators and technicians should know the closest location of the following safety related
items in your facility:
! Eye-Wash Station ! MSDS Station
! First Aid Station ! Fire Extinguisher
! Emergency Telephone ! Emergency Exits
• If in a confined room, ensure adequate and uninterrupted air ventilation, heating, and cooling
to meet environmental stress limits of personnel and the dispensing system.
• Where volatile organic compound (VOC) emissions can exceed safe limits, facility
ventilation and filtration systems must be operational.
• Provide adequate space around the dispensing system to allow for movement of maintenance
and service personnel. Allow space for access doors and service panels to open fully.
• Make sure all facility power sources are safely grounded.
• Routinely inspect all air hoses and electrical cables for damage.
• Make sure power cords and air supply hoses do not cross a walkway or aisle.
• Make sure power and air connections to the dispensing system are securely attached.
• Take earthquake precautionary measures as appropriate for earthquake-prone regions. Refer
to “
Earthquake Precautions” in this section.
• Maintain a clean and orderly work area.
• Strictly follow facility clean room practices.
• Dispose of hazardous materials and items contaminated with hazardous materials in
accordance with applicable national and local statutes and regulations, facility practice, and
the material manufacturer's MSDS.
• Always replace damaged or worn Safety Warning Labels on the dispensing system with new
labels. See “
Safety Warning Labels” later in this section for part numbers.
Safety 2-3