Installation Manual

Troubleshooting 8-3
Tools and Materials Needed
The following tools and materials are necessary to perform the troubleshooting procedures listed in this
section:
• Axiom X-1000 Series Operations Manual
• Alignment Tools, Linear Encoder, P/N 194983
• Axiom X-1000 Series Electrical Schematics and Pneumatic Diagrams (see Appendixes)
• Cable Tensioning Tool, P/N 48-8002
• Electrostatic Damage (ESD) Precautionary Material
• FmNT User Guide
• Multimeter (or other devices to measure Ohm, VAC, VDC)
• Personal Protective Equipment (PPE)
• Plastic Card, Opaque, approximately 2.5 x 3.5 inch (6.5 x 9 cm) (Homing Test)
• Power, Facility, Electrical and Pneumatic
• Screw Driver Set, Phillips Head
• Screwdriver Set, Flathead
• Test Kit, P/N TS-03
• Weight, Standard
• Wrench Set, Hex, Metric
• Wrench, Open End (or Adjustable), 10 mm
• Wrench, Torque, 10 to100 in-lbs (0.11 to 1.15 kg-m)
Planning
Fault diagnosis may vary from easy and obvious to advanced and time-consuming. Procedures may
require several system power-up and power-down cycles. Each cycle may require the system to reach
operating temperature and be allowed to cool down. Planning of scheduled maintenance is essential to
minimize the need for unscheduled downtime.
? NOTE To facilitate references to engineering drawings, some nomenclature in this section is
derived from the engineering drawings which may differ from the nomenclature used
elsewhere in this manual.
TIP Have the listed tools, materials, and electrical diagrams on hand before you start. Review
electrical paths and identify referenced part numbers using the Appendixes at the end of
this manual. Follow the steps in the Parts Replacement section of this manual to correctly
order replacement parts.