Installation Manual

Calibration and Adjustment 6-31
9. Set the Valve 1 fluid pressure to the desired level for your application by turning the knob on
the Valve 1 Fluid Pressure Regulator clockwise until the correct pressure is displayed on the
screen.
TIP To ensure accurate pressure measurement, allow the gauge to warm up for
20 to 30 minutes before adjusting pressure level.
10. If applicable to your system configuration, repeat Steps 1 through 9 for the Valve 2 Fluid Air
Pressure Gauge.
Item Description
1 Indicators - Switch Output 1 (green LED) and Output 2 (red LED)
2 Up Button
3 Set Button
4 Down Button
5LED Display
Figure 6-14 Setting a Digital Pressure Gauge
35.
4
OUT 1
OUT 2
SET
SMC
MPa
3
5
2
1
4