Installation Manual

Table of Contents xiii
Figure 9-4 Cable Tensioner Locations ............................................................................... 9-10
Figure 9-5 Tensioning the Positioner Cables ..................................................................... 9-11
Figure 9-6 Linear Bearing Locations .................................................................................. 9-13
Figure 9-7 Accessing the Positioner Cables ...................................................................... 9-15
Figure 10-1 System Access Locations ................................................................................ 10-4
Figure 10-2 Board and Panel-Mounted Fuses ..................................................................... 10-7
Figure 10-3 Box-Mounted Fuse Replacement ................................................................... 10-10
Figure 10-4 Removing/Installing the Solenoid Valve Access Hatch Cover ........................ 10-12
Figure 10-5 Pneumatic Solenoid Valve Replacement ....................................................... 10-13
Figure 10-6 Conveyor Belt Removal/Installation................................................................ 10-15
Figure 10-7 Removing/Installing the Scale Control Module ............................................... 10-18
Figure 10-8 Removing/Installing the Dispensing Area Front Cover ................................... 10-19
Figure 10-9 Removing/Installing the Dispensing Calibration Module ................................ 10-20
Figure 10-10 Removing/Installing the Heater Tooling Plate ................................................ 10-21
Figure 10-11 Removing/Installing the Lift Table .................................................................. 10-22
Figure 10-12 Removing/Installing the Balance Module ....................................................... 10-23
Figure 10-13 Dispensing Head Front View .......................................................................... 10-27
Figure 10-14 Valve 2 Bulkheads .......................................................................................... 10-29
Figure 10-15 Dispensing Head Front View .......................................................................... 10-30
Figure 10-16 Dispensing Head Rear View........................................................................... 10-31
Figure 10-17 Computer Removal/Installation ...................................................................... 10-37
Figure 10-18 Removing/Installing Computer Cards ............................................................. 10-39
Figure 10-19 PMAC Card Jumper Settings ......................................................................... 10-40
Figure 10-20 Hex Post Removal/Installation........................................................................ 10-45
Figure 10-21 Removing/Installing the Main Interface PWA ................................................. 10-47
Figure 10-22 Removing/Installing the Servo Shelf Cover .................................................... 10-49
Figure 10-23 Removing/Installing Servo Shelf PWAs.......................................................... 10-50